Wedge Type Anchor Bolt, Steel, Zinc Finish, 3/8 x 2"
(Pack of
25)
Zinc-plated, rust-resistant steel
Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Couldn't load pickup availability
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
Catalog page#: 6-31
Frequently Bought Together
Wing-Type Toggle Bolt Anchor Steel #10-24 x 4"
Couldn't load pickup availability
Drop-In Anchor Steel 1/4 x 1"
Couldn't load pickup availability
SnapSkru® Standard Self-Drilling Wall Anchor Nylon
Couldn't load pickup availability
Flat Washer Grade 12 Thru-Hardened Steel M6
Couldn't load pickup availability
SAE J995C Locknut with Nylon Insert Grade 8 5/8-11
Couldn't load pickup availability
Hex Nut Grade 5 Steel 1/2-13
Couldn't load pickup availability
SAE J995C Locknut with Nylon Insert Grade 8 1/2-13
Couldn't load pickup availability
Qwik Stik® Electrolyte Powder Mix Grape
Couldn't load pickup availability
USS Flat Washer Thru-Hardened Steel 5/16"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor SS 3/8 x 2-3/4"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor SS 5/8 x 4-1/4"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor SS 1/4 x 3-1/4"
Couldn't load pickup availability
Product Description
Zinc-plated, rust-resistant steel Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Technical Specifications
| Item#: | 92855 |
|---|---|
| Diameter | 3/8 " |
| Length | 2 " |
| Thread Length | 7/8 " |
| Drill Size | 3/8 " |
| Material | Carbon Steel |
| Finish | Bright Zinc |
| Type | Wedge Anchor |
| Size | 3/8X2 " |
| Minimum Embedment | 1-1/2 " |
| UNSPSC #: | 31162101 |
| TAA Compliant: | No |
| Weight: | 1.88 lb |
Product Restrictions
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
