Wedge Type Anchor Bolt Steel 3/4 x 5"
(Pack of
2.0)
• Zinc-plated, rust-resistant steel
• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Couldn't load pickup availability
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
Catalog page#: 6-31
Frequently Bought Together
Conical Screw Anchor Plastic #8 to #10 x 7/8"
Couldn't load pickup availability
Wing-Type Toggle Bolt Anchor Steel #10-24 x 3"
Couldn't load pickup availability
Masonry Anchor Hex Washer Head Steel 3/16 x 1-1/4"
Couldn't load pickup availability
IFI 100/107 Top Locknut Grade C 5/8-11
Couldn't load pickup availability
Hex Nut Grade 8 Alloy Steel 3/8-16
Couldn't load pickup availability
PTO Pin Lock 1/4 x 2-1/2"
Couldn't load pickup availability
Butt Connector 16 to 14 AWG Clear
Couldn't load pickup availability
USS Flat Washer Thru-Hardened Steel 1/4"
Couldn't load pickup availability
Butt Connector 22 to 18 AWG Clear
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 1/2 x 3-3/4"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 1/2 x 4-1/4"
Couldn't load pickup availability
Wedge Type Stud Bolt Anchor Steel 3/4 x 5-1/2"
Couldn't load pickup availability
Product Description
• Zinc-plated, rust-resistant steel• Meets the following specifications: OSHA Section 1910.212 (b), I.C.B.O. No. 1821, GSA FFS-325 and ASTM B633
• Designed for installation in concrete block, brick and stone
1. Drill hole to depth equal to length of Wej-It® Anchor Bolt. Clean hole with compressed air and wire brush.
2. Drive Wej-It® Anchor Bolt into drilled hole through fixture until washer is flush with fixture.
3. Tighten the nut three to five turns past the hand-tight position.
Technical Specifications
| Item#: | 92865 |
|---|---|
| Diameter | 3/4 " |
| Length | 5 " |
| Thread Length | 1-1/2 " |
| Drill Size | 3/4 " |
| Material | Carbon Steel |
| Finish | Bright Zinc |
| Type | Wedge Anchor |
| Size | 3/4X5 " |
| Minimum Embedment | 3 " |
| UNSPSC #: | 31162101 |
| TAA Compliant: | No |
| Weight: | 1.43 lb |
Product Restrictions
California Proposition 65: Not Applicable
www.P65Warnings.ca.gov
